If you're like me, you have a good collection of wooden stamps that take up much space and you use little, because you tend to forget them and to use your stamps transparent. Here is a simple and rapid to convert your wooden stamps stamps can be mounted on a block of acrylic.
You will need:
- at least one good pair of scissors (I took my big scissors and my scissors precision)
- pencil
- a sheet of EZ Mount
- Sharpie pen
- a Wooden stamp!
1. Gently peel your stamp of its foam. Rub the bottom of your stamp to remove any residual foam.
According to the company and the age of your stamp, you may have difficulty to take off. If so, you can put your stamp in the microwave (yes!) For 10 seconds. This will soften the adhesive without damaging the stamp. Be careful not to burn yourself!
2. Trace around your stamp on your sheet of EZ Mount. Cut.
3. Remove the protective paper on the side of writing. Paste your stamp gently on the EZ Mount.
4. Using your scissors precision cut excess EZ Mount, if applicable.
5. Remove the white liner on your stamp.
6. And voila! Your stamp is now fixed on an acrylic block and you're ready to stamp!
If you want to keep the name of your stamp and its manufacturer, you can register it behind your stamp using a Sharpie pen.
What to do with your block of wood? If the foam is still on the block and in good condition, especially if it has an interesting shape, you can keep on the block and make a stamp with foam. You could even superimpose images stamped foam and stamp. You can also keep the block and attaching sandpaper to a tool of "distressing" low cost! Good
stamping!
***************
If You're Like Me, You Might Have SEVERAL wood stamps take up a lot That of room and get very little use, tends to forget Because You about 'em and just use your acrylic stamps. Here's a simple and easy method for converting unmounting your stamps and stamps cling to 'em.
You Will Need:
- at least one good pair of scissors (I used my big scissors and my precision scissors)
- a pencil
- an EZ Mount sheet
- a Sharpie pen
- and a wood stamp!
1. Carefully peel off your stamp from the mounting foam. Rub the underside of the stamp to remove all traces of foam.
Depending on the manufacturer or the age of your stamp, you might have difficulties peeling it off the foam. If such is the case, you can place your stamp in the microwave for 10 seconds. It will loosen the adhesive. Be careful not to burn yourself!
2. Trace your stamp on an EZ Mount sheet. Cut out the EZ Mount in the traced shape.
3. Peel off the paper off the cut out piece (the side with the writing). Carefully adhere your stamp to the EZ Mount.
4. Using your precision scissors, cut off the excess around your stamp, if necessary.
5. Peel off the white paper from the backside of your stamp.
6. That's it! Your stamp is now ready to mount on an acrylic block!
If you wish to save the name of your stamp and its manufacturer, you can simple write it on the backside of your stamp with a Sharpie.
And what should you do with the wooden block? If the mounting foam is still on the block, in good condition, and has an interesting shape, you could use it as a foam stamp. You could even layer the stamped images from the foam and rubber stamp. You can also use the wooden block as a sanding block by adding sand paper to it for a free distressing tool!
Happy stamping!
0 comments:
Post a Comment